Factory Replacement 120 Volt Direct Spark Ignition Module (Fenwal)

Factory Replacement 120 Volt Direct Spark Ignition Module (Fenwal)
Product Code: CIRFE3
Availability: In Stock
Price: $197.89
Ex Tax: $197.89
   - OR -   

Factory Replacement 120 Volt Direct Spark Ignition Module (Fenwal)


Fenwal 05-38 Series is a 120 VAC direct spark ignition

control. The 05-38 Series provides positive ignition of main burners

when heat is required. The ignition spark operates until the flame is established

and then immediately shuts off. The flame sensing circuitry is positive

and fail-safe. If after a try-for-ignition, a flame is not present, the unit

goes into lockout de-energizing the gas valve automatically. Resetting after

the lockout is accomplished by cycling the wall thermostat down to its lowest

setting then back to the desired comfort setting. If the flame is lost during

normal heat cycle, a new trial-for-ignition sequence will commence.

Models with remote and with local flame sensing are available. See ordering

chart for specific model functions.


Electrical rating (input) 120 VAC 50/60 Hz

Nominal current drain (running) 90 mA max.

(during ignition) 270 mA max.

without valve power

Gas valve relay ratings 2.5 amp max.

5.0 amp max. in rush

Technical Data:

Pre-Purge: No

Sensor Type: Remote/Local-Single Spark & Ignition

Ignition Attempts (Before Lockout): 1

Valve Trial Time (Seconds): 5

Module Supply Voltage (VAC): 120

Enclosed: Yes

Connections: 1/4" Q.C.

Replaces Part Numbers:


Used in Equipment Model Numbers:

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:


Copyright © 2012 All rights reserved | Developed by